SOLAR LIGHT
WITH WALL MOUNT
AND STAKE
90729
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
©
®
Copyright 2003 by Harbor FreightTools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or
form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
10. Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for any broken parts or mounting fixtures; and
any other condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician.
11. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this product. Approved accessories are available from Harbor
Freight Tools.
12. Do not setup the product if under the influence of alcohol or drugs. Read
warning labels if taking prescription medicine to determine if your judgment or reflexes
are impaired while taking drugs. If there is any doubt, do not setup the product.
13. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
Warning:The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Specific Solar Light Warnings
1.
2.
3.
The Solar light must be installed in a sunny location where it will receive at least 8
hours of sunlight daily. Do not allow anything to shade or cover the Solar Light, or it
will keep the solar panel from absorbing enough sunlight to operate at full capacity.
For best lighting results, it is recommended that you do not space Solar Lights more
than 12 feet apart. Do not place Solar Lights less than five feet from each other or
they may cause the lights to flicker from such a close adjacent light source.
Position the Solar Light away from any other night lighting sources as they may
interfere with the lights ability to turn on and off automatically.
Unpacking
When unpacking, check to make sure the parts listed on page 7 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible.
REV 06/04
SKU 90729
For technical questions, please call 1-800-444-3353.
Page 3
Assembly
Ground Staked Installation
See the Assembly Drawing on page 7.
Note: Ground Stake parts assemble by simply slip-fitting them together.
1.
Assemble the Ground Stake by fitting a Stake Connector (3) into the Pointed Ground
Stake (4), then add, a Ground Stake Tube (2) to the Stake Connector (3). Then, add
another Stake Connector (3) and another Ground Stake Tube (2). Lastly, insert the top
Ground Stake Tube (2) into the Light Fixture (1).
2.
3.
Choose a location away from other night time light sources and dig a hole
approximately 6 inches in the ground. If the ground is hard, soak it with water prior to
digging.
Work the Light stake into the ground without forcing it or hammering it. Forcing or
hammering will break the Light Stake and permanently damage the Solar Light. Fill in
the dirt around the Stake and make sure it is stable. See FIGURE 1.
FIGURE 1
FIGURE 2
Light Fixture (1)
Assembled
Ground Stake
Light Fixture (1)
Wall Bracket (5)
Wall Bracket Installation
1.
At the desired location, use the holes in the Wall Bracket (5) for a template and draw
two screw hole circles on the mounting surface. Predrill, being careful not to drill into
hidden electrical wires or cables. Make sure the wall is solid or has a stud behind the
surface that will hold the weight of the Solar Light. Mount the Wall Bracket (5) with the
two screws provided.
2.
Insert the Light Fixture (1) into the Wall Bracket (5) making sure the light sensor is
pointing away from any other night time light source. See FIGURE 2.
SKU 90729
For technical questions, please call 1-800-444-3353.
Page 4
Operation
1.
2.
Remove the Cap and turn the switch to “ON”. Replace the Cap. Now charge the
Solar Light in direct sunlight for at least 3 sunny days.
This period is called the “Charging Period” because, during the initial three days, the
lamp may not illuminate up to its full duration.
You will only need to turn on the unit once, and from then on it will switch on and off
automatically. See FIGURE 3.
FIGURE 3
Switch
Cap
LED
Note: We recommend testing the light by waiting until after the 3 day initial charge period
and then taking the Solar Light indoors into a dark room to make sure it comes on
automatically.
Troubleshooting
Dim Light:
1.
The on/off switch contacts may be poor. Turn the switch on and off several times to
alleviate the problem.
2.
The battery may be low or under charged. Make sure the Solar Light is located in an
unobstructed location where it will receive 8 hours of sun. Allow the battery to
recharge for 5 full, sunny days. Overcast days will limit performance.
3.
Dirty Solar Panel (on top of the Cap). A dirty Solar Panel will not allow the unit to
charge, shortening the life of the battery. Clean the Solar Panel regularly with a damp
cloth. Do not use detergents or solvents.
No Light:
1.
An external light source (i.e. streetlight, porch light, flood light) may prevent the light
from turning on. Reposition the Solar Light.
2.
Batteries may need recharging.
REV 05/05
SKU 90729
For technical questions, please call 1-800-444-3353.
Page 5
Maintenance
1.
This Solar Light is designed for year-round outdoor usage. If you intend to store it
indoors for more than 2-3 days, follow the following protocols:
a. Store in a dry location at room temperature.
b. During storage, the battery still needs some light to keep it charging so it will not
become completely discharged. Store it where it can receive minimal sun or room
light.
c. During prolonged storage you should switch the power switch to the OFF position.
Note: We do not recommend storing the Solar Light for long periods of time.
2.
Make sure the Solar Panel is clean and clear of any dirt or debris. Use a soft, damp
cloth to clean the Solar Panel. Do not use bleaches or detergents.
Note: The bulb (LED type) cannot be replaced.
3.
This light has delicate wiring inside. The Battery should only be replaced by a
qualified service technician. The battery should only be replaced by another “AA” (L6)
Ni-Cd, 600 mAh minimum battery.
REV 06/04
SKU 90729
For technical questions, please call 1-800-444-3353.
Page 6
Parts List
Part No.
Description
Light Fixture
Ground Stake Tubes
Stake Connectors
Pointed Ground Stake
Wall Bracket
Qty.
1
2
2
1
1
2
3
4
5
6
1
2
Mounting Screws
Assembly Drawing
2
3
4
1
5
Note: The Mounting Screws (6) are not shown.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDEDTHE PARTS DIAGRAM INTHIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE
IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-
MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR
HER REPAIRSTOTHE ORIGINAL PRODUCT OR REPLACEMENT PARTSTHERETO, OR ARIS-
ING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
SKU 90729
For technical questions, please call 1-800-444-3353.
Page 7
|